Fuel Injection Technical Library » Two Digit Codes 59-74

#	KOEO	CM	KOER	Code Definition
59	X	X		Low speed fuel pump circuit failure.
59	X	X		2 – 3 shift error (E4OD).
60			X	Cylinder #6 Failed Cylinder Balance Test.
61	X			ECT sensor is less than the Self-Test minimum of 0.2 volts.
61		X		ECT sensor has intermittently failed below 0.2 volts.
62	X			4/3 or 3/2 pressure switch circuit failed open.
62		X		Converter clutch error (E4OD).
63	X			TPS circuit below minimum 0.6 volts.
63		X		TPS circuit has intermittently failed below minimum 0.6 volts.
64	X			ACT sensor is less than the Self-Test minimum of 0.2 volts.
64		X		ACT sensor has intermittently failed below 0.2 volts.
65			X	Overdrive OFF switch was not cycled during KOER test (user error).
66		X		MAF sensor went below 0.4 volts during the last 80 warm-up cycles.
66	X	X		TOT sensor output was less than Self-Test minimum value of 0.15 volts.
67	X	X		Neutral safety circuit failure.
67			X	A/C circuit was on during KOER Self-Test.
68		X		Transmission recently overheated, or TOT sensor intermittently failed below 0.2 volts.
69		X		3 – 4 shift error.
70			X	Cylinder #7 Failed Cylinder Balance Test.
71		X		Software re-initialization detected or Cluster ControlAssembly circuit failed.
72		X		Power interruption detected or Message Center Control Assembly circuit failed.
72			X	Insufficient MAF/MAP change during Dynamic Response Test (user error).
73			X	TPS senor did not exceed 25% rotation during Dynamic Response Test (user error).
74			X	Brake On/Off switch not actuated during KOER test (user error).

KOEO = Key On Engine Off, CM = Continues Memory, KOER = Key On Engine Running